Rock slab deep processing equipment

Before cutting, check the cutting machine to ensure that the workbench must be clean, durable and solid.If a diamond cutting blade is used to cut the rock slab, it is necessary to ensure that the rock slab is fed in the same direction as the rotation of the cutting blade. The slower the material speed, the better the cutting effect.

When cutting, make sure that the bottom of the rock slab is completely located on a flat console, and the slab is flat and not tilted.In order to avoid vibration caused by cutting, it is recommended to place a rubber or wooden anvil between the rock slab and the console.

With the help of professional opening equipment, square holes, round holes and other hole types can be opened on hard rock slabs. When opening the hole, water needs to be used to assist in cooling down.

Before opening the rock slab, you must plan the cutting position of the plate to ensure that the plate can better withstand the cutting pressure. Please try to make the hole in the middle of the rock slab. There must always be at least 5 cm from the hole to the edge of the plate.

The inner corners of the right angles can be cut directly by waterjet, but it is not recommended.Because of this inner angle design, during processing, handling, transportation and installation, the risk of table top rupture will be increased.Draw an arc length with a radius of 5mm at each corner to disperse the pressure.

Select the position of the opening on the front of the large rock slab to open a round hole. After the glass drill is started, it will slowly cut in at a 45-degree tilt, and then cut vertically after stabilization.

It is recommended to treat the edges of the rock slab countertops with rounded corners or beveled cuts, which can make the countertops more impact-resistant, beautiful and safe.After the corresponding processing parameters are set in the edging machine, the equipment can be started