What is the reason for the collapse of the rear edge and bottom of Antai Mingjia CNC automatic special-shaped edger?

With the development of society, it is getting faster and faster. Of course, some industries are also following the society and constantly improving their functions in order to make their products better. The automatic glass edger is one of them, so what is the reason for the collapse of the rear edge and bottom of the automatic glass edger? Let's analyze it.

1. The edging speed should be appropriately reduced, the splint has been worn, and the skin is much better than the glass edging machine.

2. Insufficient water.

3. The distribution of glass grinding amount is uneven.

4. The grinding wheel is not sharp enough. The water pipe is blocked in the glass edger with too high water temperature, and the chain is too long.

5. THE ORIGINAL MOVIE HAS BUBBLES AND STONES. In particular, the stones inside the glass can easily break the glass edger in the heated part.

6. No dark cracks are found on the edge or opening of the glass. The heated part of the glass edger is damaged.

The solution is to adjust the amount of uniform grinding and the amount of water added. Glass grinds too much, too fast. The above is to introduce the reasons for the collapse of the feet behind the automatic glass edging machine, I hope to help you.