Antai Mingjia CNC automatic special-shaped edge grinding machine introduction

     If the CNC automatic special-shaped glass edging machine is used for internal lamination, this section is used for flat pressing of insulating glass. This section has upper and lower stepping motors and eight-zone suction cups, which can well control the accurate lamination of glass. The flat pressing process is controlled by the hydraulic system, and the active pressing of the closed insulating glass is completed in the flat pressing section. The feature of this part is the use of glass center positioning, which can make the parallel pressure of the insulating glass uniform, and jointly improve the working conditions of the equipment.

     If the CNC automatic special-shaped glass edging machine is used for internal lamination, this section is used for flat pressing of insulating glass. This section has upper and lower stepping motors and eight-zone suction cups, which can well control the accurate lamination of glass. The flat pressing process is controlled by the hydraulic system, and the active pressing of the closed insulating glass is completed in the flat pressing section. The feature of this part is the use of glass center positioning, which can make the parallel pressure of the insulating glass uniform, and jointly improve the working conditions of the equipment.

The positioning principle of Antai Mingjia CNC automatic special-shaped edging machine is:

   Detected by the initial photoelectric switch and the central photoelectric switch entering the section, the insulating glass stops at the center position, and the pressure of this section is controlled by the micro switch. In the case of internal lamination or surface internal lamination, this part is used for lamination and flat lamination of insulating glass. The insulating glass production line has two processes: SM1800A, SM2200A and SM2500A are operated by hydraulic system, SM1600 is operated by pneumatic system, and the pneumatic system is automatically completed in the lamination and flattening section, which greatly reduces the structural length of the entire insulating glass production line.

   When using the automatic special-shaped glass edging machine, you should pay attention to the grinding condition at any time, and the wear and tear of the grinding wheel should be compensated in time. Always insist that the cooling water volume of the water tank is sufficient, the water quality is cleaned, to prevent the grinding wheel and glass from burning, and to sort out the grinding impurities in the water inlet and outlet pipes in time, and insist on dredging the waterway. Whether the direction is correct, if it is inaccurate or the control direction is wrong, stop the machine immediately to check, otherwise the machine will be in danger of damage.